01 / END-VIEW
See what Side-View cannot reveal
End-face imaging supports alignment of cores, capillaries and irregular structures.
FITEL S185 · FIBER PROCESS LAB
Do not select a splicer alone.
Design the complete process.
Answer a few questions about your fibers and applications. The configurator recommends an S185 platform or an appropriate 3SAE system, together with equipment for preparation, inspection, recoating and parameter verification.
- 8S185 variants
- 30–2500 µmanalyzed process range
- 1 reportready for consultation
LIVE PROCESS VIEWROF / 3E
CONTROLLED HEAT ZONE
Controlled heat source
positioning · rotation · heat profile
END-VIEW19-core MCF
Complete system
- 01Strip
- 02Clean
- 03Cleave
- 04Inspect
- 05Splice
- 06Recoat
- 07Verify
SYSTEM DESIGNER / 01
Tell us about your fibers
The recommendation is engineering-based but preliminary. Non-standard geometries and processes are confirmed using application samples.
RECOMMENDATION / TECHNOLOGY SYSTEM
Your preliminary workstation design
WITHIN RANGE
TECHNOLOGY PREVIEW ● LIVE
RECOMMENDED PLATFORM
FITEL S185EVROF
END-VIEW + ROFA system for the most demanding microstructured fibers, combining end-face imaging with a controlled heat source.
OPTION
Active Tilt Alignment (ATA)
Factory option — it must be ordered with the new splicer and cannot be retrofitted later.
EXTENSION
SELECTED HOLDERS713-250for Ø 250 µm coating
LAB COVERAGE MATRIX
Research profile coverage
Each profile is checked against the base platform and any required extension.
covered by base platform extension required system consultation
RECOMMENDED WORKFLOW
Process equipment
i
Why is sample verification required?
Specialty fibers differ in more than diameter. Materials, refractive-index profile, hole geometry, coating type and target optical load all matter. The final system and splicing recipe are confirmed by an application engineer.
TECHNOLOGY / 02
Three perspectives on one splice
In the S185, mechanics, imaging and the heat source form one controlled process.
The configurator logic is based on current FITEL / Furukawa Electric, 3SAE and NorthLab materials. It is a preselection tool and does not replace application validation.